As a basic machine, Prensa plegadora CNC is very common in various factories. If its maintenance measures can improve the efficiency of the work and the service life of the bending machine itself, we will introduce its maintenance content below:
1. Circuito de aceite hidráulico
- The hydraulic oil used by CNC Press Brake is ISOHM46 or MOBILDTE25;
- 1) Revise el nivel de aceite del tanque semanalmente. Si se repara el sistema hidráulico, debe revisarse. Si el nivel de aceite es inferior a la mirilla, agregue aceite hidráulico.;
- The system oil temperature should be between 35 ° C and 60 ° C, and should not exceed 70 ° C. If the temperature is too high, the oil quality and accessories will be deteriorated and damaged.
- The new press brake should be changed after 2000 hours of operation. After every 4000-6000 hours of operation, the oil should be changed. Every time the oil is changed, the oil tank should be cleaned;
2. the filter
- The CNC Press Brake machine has related alarms or oil quality is not clean and other filters are abnormal, should be replaced;
- Cada vez que se cambia el aceite, se debe reemplazar el filtro o limpiarlo completamente.
- Check and clean the air filter on the fuel tank every 3 months, and try to replace it every year.
3. Componentes hidráulicos
- After using CNC Press Brake for one month, check if there is any deformation at the bend of each tubing. If there is any abnormality, it should be replaced. After two months of use, the joints of all accessories should be tightened. The system should be shut down during this work. No stress.
- 1) Limpiar mensualmente los componentes hidráulicos (sustratos, válvulas, motores, bombas, tuberías de aceite, etc.) para evitar que entre suciedad en el sistema y no poder utilizar agentes de limpieza;
Conozca más sobre nuestros productos, visite y suscríbase a nuestro Canal de Youtube
